Home Forums HAast (High Availability for Asterisk) Configuration & Optimization Lose contact with PBX when node is active

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • Avatar photoCustomer Inquiry
    Member
    Post count: 197

    I am setting up a small office PBX cluster. My network settings are:

    Active Node: IP 192.168.1.1, Netmask 255.255.255.0
    Passive Node: IP 192.168.1.2, Netmask 255.255.255.0
    VoIP NIC: IP 192.168.1.3, Netmask 255.255.255.0

    When either node goes active I lose contact with it – sometimes, from some phones. What is going on?

    Avatar photoTelium Support Group
    Member
    Post count: 258

    I think you are missing some basics concepts of networking. Your description above shows two NIC’s on the same subnet. That will confuse Linux as it is not sure which NIC to use for incoming/outgoing traffic.

    Carefully review section 2.4 of the HAAst installation guide before going any further. If you are new to networking/multihoming/routing then you will find all HA product difficult to install or get working properly.

    If this is for a commercial environment I would recommend you engage Telium professional services to perform the installation for you (or at least the network/VoIP NIC portion). If you wish, our engineers can also walk you through the key concepts of networking and multihoming, to help you understand what they configured and why.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.